IP6X is the highest dust protection rating in the IEC 60529 standard. It specifies that a case is dust-tight — no dust can penetrate the interior even after 8 hours of continuous exposure to circulating talcum powder in a dust chamber. Our Series 8 cases were tested by CTI to verify IP6X compliance.
After 8 hours of exposure, all 3 sample cases showed zero dust ingress when opened and inspected under 10x magnification. The test was conducted per IEC 60529 Section 13.4 (Category 1 enclosure).
IP6X performance is critical for operations in:
IP6X is the highest dust protection rating per IEC 60529. The case is dust-tight with zero dust ingress after 8 hours of exposure.
Talcum powder, median particle size 75μm per IEC 60529 specification.
Desert operations, mining, construction, agricultural settings with high particulate.
IP6x is the dust protection rating per IEC 60529. The '6' indicates complete protection against dust ingress. No dust can penetrate the case under continuous airflow exposure for 8 hours at specified pressure (2 kPa).
Test per IEC 60529: case is placed in a dust chamber with circulating talcum powder (or Arizona road dust) for 8 hours. Pressure differential: 2 kPa (8x normal atmospheric pressure difference). After test, no dust should be visible inside the case.
IP5x: dust-protected (not fully sealed, some dust may enter but not in quantities that interfere with operation). IP6x: dust-tight (no dust ingress). Our premium cases meet IP6x.
Yes. IP6x only tests dust protection. For water protection, look for IPx5, IPx6, IPx7, or IPx8. Our premium cases meet IP67: dust-tight (6) and waterproof to 1m for 30 minutes (7).
Industries requiring IP6x: mining, construction, agriculture, desert operations, cement plants, grain handling, pharmaceutical (cleanroom), semiconductor (cleanroom), military, and any environment with airborne particulates.
Similar but not identical. Mil-Std-810 Method 510.7 uses 1-3 hours of dust exposure at varying wind speeds (1.5-8.9 m/s) at temperatures up to 60°C. IP6x uses 8 hours of dust at 2 kPa pressure. Both certify dust-tightness; we test to both standards.
IP6x dust chamber test: 8 hours exposure + 1-2 hours inspection. Full qualification: 2-3 days including pre-conditioning, dust exposure, post-conditioning, and inspection. We provide detailed test reports with photos.
Sand is more aggressive than dust due to larger particle size. We test our cases per Mil-Std-810 Method 510.7 (sand and dust) and IP6x (fine dust). Our cases pass both: no sand or dust ingress after 8 hours.
Yes. All our premium cases are IP6x certified. Test certificates available for every batch. We test in our in-house lab and verify with third-party labs (TUV, SGS) annually for certification renewal.
Yes. We provide IP6x test reports on request with NDA. Reports include: test setup, dust concentration, exposure time, post-test inspection photos, and certification signature. Available in PDF and JSON formats.